LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Glow Plug System - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Glow Plug System - INGENIUM I4 2.0L Diesel >> Glow Plugs (G1817201) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Extreme cleanliness must be exercised when handling these components.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: High Pressure Exhaust Gas Recirculation (EGR) Valve (Removal and Installation).

  4. G11308051

    Disconnect the glow plug wires.

  5. CAUTION:
    • Make sure not to interchange the glow plugs between cylinders during service of the engine. If one or more glow plugs have to be removed from the engine, make sure that they're clearly labelled with the cylinder number, so that they are not mixed up during installation into the engine.
    • Make sure that the area around the component is clean and free of foreign material.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11308052

    Torque Specification: 18 Nm 

scientia non olet · About LEMON Manuals