LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Rear Suspension -- XE (X760)) >> Rear Suspension >> Wheel Knuckle >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If a new knuckle is to be installed, a new wheel bearing will be required.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  1. Deactivate the electronic park brake.

    Refer to: Electronic Parking Brake Service Mode Activation and Deactivation .

  2. Raise and support the vehicle.

    Refer to: Lifting .

  3. Remove the wheel and tire.

    Refer to: Wheel and Tire .

  4. CAUTION: Do not use air tools to remove the halfshaft nut.
    NOTE: Retain the nut for use in the installation procedure.
    G11305613
  5. CAUTION: Do not use excessive force to remove the component.
    G11305614
  6. CAUTION:
    • Discard the bolts.
    • Do not allow the brake caliper to hang on the brake hose.
    G11305615
  7. WARNING: Using a suitable stand, support the lower arm.
    CAUTION: Discard the nut and bolt.
    G11305616
  8. CAUTION: Discard the nut and bolt.
    G11305617
  9. CAUTION: Discard the nuts and bolts.
    G11305618
  10. NOTE: Discard the nuts and bolts.
    G11305619
  11. G11305620

    Special Tool(s):  205-857

  12. WARNING: The component(s) may be heavy. Take extra care when handling.
    CAUTION: Discard the bolt.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11305621
  13. G11305622
  14. G11305623
G11305624
scientia non olet · About LEMON Manuals