Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To prevent any stress being applied to the brake hose, make sure the suspension is supported before disconnecting the rear shock absorber from the hub.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

Raise the vehicle.
WARNING: Make sure to support the vehicle with axle stands.
Remove the wheel and tire.
Refer to: Wheel and Tire .
Using a suitable stand, support the lower arm.
NOTE: Vehicles with active damping.
CAUTION: Discard the nuts.

Renew Part: Shock absorber upper mounting nuts Quantity: 2

Torque Specifications:

Stage 1: 48 Nm

Stage 2: 60°
CAUTION:
- Discard the nut and bolt.
- Nuts and bolts must be tightened with vehicle at normal ride height.
NOTE: Do not disassemble further if the component is removed for access only.

Torque Specifications:

Stage 1: 70 Nm

Stage 2: 120°
Inspect the components and renew if damaged or worn.
CAUTION: Discard the nut.

Renew Part: Shock absorber nut Quantity: 1

Torque Specifications:

Active dampers 27 Nm

Passive dampers 40 Nm