LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Speed Control - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Speed Control - INGENIUM I4 2.0L Petrol >> Speed Control Switch >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Make the Supplemental Restraint System (SRS) safe.

    Refer to: Standard Workshop Practices .

  2. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Remove the driver airbag.

    Refer to: Driver Airbag Module .

  4. NOTE: Make sure that the harness is routed to the position noted on removal.
    G11314895
    • Remove the retaining screws.
    • Partially remove the paddle shifter.
    • Disconnect the electrical connector.
    • Remove the paddle shifter.
  5. G11314896
scientia non olet · About LEMON Manuals