LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Steering Column -- XE (X760)) >> Steering Column >> Steering Wheel >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Allow a period of 10 minutes to elapse after disconnecting the battery before undertaking any work on the SRS.
  • To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplementary restraints system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait for one minute. Failure to follow this instruction may result in personal injury.
  • Take extra care when handling SRS components.
CAUTION: Make sure that the road wheels are in the straight ahead position.
NOTE: Removal steps in this procedure may contain installation details.
  1. Make the SRS system safe.

    Refer to: Standard Workshop Practices .

  2. Remove the driver air bag module.

    Refer to: Driver Airbag Module .

  3. G11308831

    Torque: 48 Nm 

  4. CAUTION: Make sure that the wheels and tires are in the straight-ahead position. Failure to follow this instruction may result in damage to the components.
    NOTE: Note the steering wheel to column alignment mark.
    G11308832
  5. Secure with adhesive tape.
    CAUTION: Make sure that the clockspring rotor does not rotate.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11308806
  6. G11308834
  7. G11308835
  8. G11308836

    Torque: 2.5 Nm 

  9. G11308837
  10. G11308838

    Torque: 6 Nm 

  11. G11308839
scientia non olet · About LEMON Manuals