LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 118 (Pedestrian Protection System -- XE (X760)) >> Pedestrian Protection System >> Pedestrian Impact Sensor (G1822166) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
    CAUTION:
    • The alignment mark on the pedestrian impact sensor tube should be aligned with the center of the bumper.
    • The pedestrian impact sensor tube must not be stretched during installation, so that the exposed length of tube at each end is not excessively long.
    • The pedestrian impact sensor tube must not be compressed during installation, so that the exposed length of tube at each end is not too short.
    • Make sure that there are no kinks in the pedestrian impact sensor tube after installation and the exposed length of tube is equal on both sides.
    • Inspect the pedestrian impact sensor for any signs of damage, such as cuts or slits. Install a new component if required.
scientia non olet · About LEMON Manuals