LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol >> Rear Knock Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Remove the intake manifold.

    Refer to: Intake Manifold .

  4. G11308596

    Disconnect the electrical connector.

  5. G11308597

    Remove the rear knock sensor.

scientia non olet · About LEMON Manuals