Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
- Install the intake Camshaft Position Sensor (CPS).
- Renew Part: Camshaft position sensor O-ring seal Quantity: 1.
- Torque Specification: 8 Nm
Connect the wiring harness.
Connect the breather pipe.
Install the engine acoustic cover.
Refer to: Engine Cover - Ingenium I4 2.0L Petrol