Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the heated oxygen sensor (HO2S).
  Special Tool(s): 310-121
  
  Torque Specification: 48 Nm
- If the sensor is not being replaced with a new component. Make sure that a suitable anti seize grease is applied to the sensor thread.
Install the catalytic converter.
Refer to: Catalytic Converter .
Lower the vehicle.
Connect the battery ground cable.
Refer to: Battery Disconnect and Connect .