LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol >> Cylinder Head Temperature Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Remove the intake air resonator.

    Refer to: Intake Air Resonator .

  2. CAUTION: This is a single use component and must be renewed if removed.
    G11308599
    • Disconnect the electrical connector.
    • Slide the retaining clip from the back of the electrical connector.
    • Remove and discard the cylinder head temperature sensor.
scientia non olet · About LEMON Manuals