Transmission Fluid Cooler Tubes - INGENIUM I4 2.0L Petrol (G1817253): Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .

General Equipment: Two-post lift
Drain the transmission fluid.
Refer to: Transmission Fluid Drain and Refill .
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
Release the 2 transmission cooler tubes from the transmission cooler assembly.
CAUTION: Be prepared to collect escaping fluid.
Remove the bolt securing the transmission fluid cooler tubes to the oil pan assembly.
Remove the bolt securing the transmission fluid cooler tubes to the transmission assembly.
CAUTION:
- Be prepared to collect escaping fluid.
- - Make sure that the area around the component is clean and free of foreign material.
  - Remove and discard the O-ring seal.
Remove the transmission cooler tubes.
CAUTION: Be prepared to collect escaping fluid.