LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Fuel Charging & Controls - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Fuel Charging And Controls - INGENIUM I4 2.0L Diesel >> Fuel Rail Supply Pipe >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure that the component is clean, free of foreign material and lubricant.
    • Install the fuel rail high pressure supply pipe.
    G11307492

    Renew Part: Fuel rail supply pipe(s) Quantity: 1

  2. G11307520
  3. CAUTION: Only tighten the union finger-tight at this stage.
    G11307444
  4. NOTE: Remove and discard the blanking cap.
    G11307522
  5. CAUTION: Only tighten the union finger-tight at this stage.
    G11307452
  6. G11307443

    Torque Specification: 11 Nm 

  7. G11307444

    Torque Specification: 

    Stage 1: 15 Nm 

    Stage 2: 62° 

  8. G11307452

    Torque Specification: 

    Stage 1: 10 Nm 

    Stage 2: 62° 

  9. G11307486

    Torque Specification: 11 Nm 

  10. G11307454

    Torque Specification: 9 Nm 

  11. CAUTION: Install a new gasket.
    G11307441

    Renew Part: EGR pipe to exhaust manifold gasket Quantity: 1

  12. G11307440

    Torque Specification: 11 Nm 

  13. G11307439
  14. G11307481
  15. NOTE: Remove and discard the blanking caps.
    G11307534
  16. G11307479
  17. NOTE: Remove and discard the blanking cap.
    G11307536
  18. G11307477
  19. NOTE: Make sure that a new gasket and O-ring seal is installed.
    G11307433

    Renew Part: EGR pipe to intake manifold O-ring seal Quantity: 1

    Renew Part: EGR cooler to EGR valve gasket Quantity: 1

    Torque Specification: 

    M6x20 7 Nm 

    M6x25 11 Nm 

  20. G11307432
  21. NOTE: Remove and discard the blanking caps.
    G11307540
  22. G11307431
  23. G11307430

    Torque Specification: 11 Nm 

  24. NOTE: Remove and discard the blanking caps.
    G11307543
  25. G11307470
  26. G11307434

    F.

  27. Install the NVH material.
    G11307404
  28. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  29. Bleed the fuel system.
    CAUTION: Bleed the fuel system by cranking the engine to purge the air from the system.
  30. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .
scientia non olet · About LEMON Manuals