LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Restraint System -- XE (X760)) >> Supplemental Restraint System >> Diagnosis And Testing >> SEATBELT Buckle Pre TENSIONER Diagnostics >> Pinpoint Test >> Pinpoint Test C: Buckle/Retractor PRETENSIONER Diagnostic

Pinpoint Test C: Buckle/Retractor PRETENSIONER Diagnostic

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. C1: DIAGNOSTIC PROCEDURE 
    • Prior to any work on the SRS system the vehicle battery must be disconnected
    • Please wait for 120 seconds to allow the airbag deployment energy reserve to dissipate
    1. Remove seat and check routing and condition of under-seat harness
    2. Ensure harness is in good condition with no damage
    3. Ensure harness is securely routed
    4. Ensure all fir tree clips and cable ties are correctly installed
    5. Reinstall seat
    6. Ensure harness is securely routed
    7. Reconnect the vehicle battery
    8. Clear the DTC, cycle the ignition state off/on wait 30 seconds and re-test
    9. To confirm repair. Whilst sitting in seat, retest as follows:
      • Seat fully up - move fully backwards and forwards 
      • Seat fully down - move fully backwards and forwards 

    Is the warning lamp illuminated?

    • Yes  : Install new component
    • No  : No further action required
scientia non olet · About LEMON Manuals