LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Supplemental Restraint System -- XE (X760)) >> Supplemental Restraint System >> CLOCKSPRING (G1818493) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
  • Never probe the connectors on the air bag module. Doing so may result in air bag deployment, which may result in personal injury. Failure to follow this instruction may result in personal injury.
  • To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait one minute. Failure to follow this instruction may result in personal injury.
CAUTION:
  • Make sure the wheels are in the straight-ahead position. Failure to follow this instruction may result in damage to the component.
  • Use a suitable trim tool.
NOTE: Removal steps in this procedure may contain installation details.
  1. Make the supplementary restraint system (SRS) safe.

    Refer to: Supplemental Restraint System (SRS) Health and Safety Precautions .

  2. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Refer to: Steering Wheel .
  4. G11312462
  5. G11308805
  6. G11308807
  7. G11312465
  8. G11312466

    Torque: 1.9 Nm 

scientia non olet · About LEMON Manuals