LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Valve Cover Vent Oil Separator >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse the removal procedure.
  2. Install the valve cover vent oil separator.
    NOTE: Inspect the seals, Replace if damaged.

    Renew Part: Crankcase oil vent oil separator to cylinder block seals. 

    Torque: 12 Nm 

  3. Install the fuel injector wiring harness and secure in position with the 3 retaining clips.
  4. Install the breather pipe onto the valve cover vent oil separator.
  5. Install the Noise, Vibration and Harshness (NVH) pad.
  6. Install the engine cover.
scientia non olet · About LEMON Manuals