Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the low pressure exhaust gas recirculation valve.
- Install a new gasket.
  Renew Part: Low pressure exhaust gas recirculation (EGR) valve to low pressure EGR cooler gasket.
- Install a new O-ring seal.
  Renew Part: Low pressure exhaust gas recirculation valve to turbocharger seal.
  
  Torque: 25 Nm
Secure the pressure sensor assembly.
Torque: 12 Nm
- Install the breather pipe.
- Install new O-ring seals.
  Renew Part: Breather hose O-ring seal.
  
  Torque: 12 Nm
Connect the electrical connectors.
Install the intake air resonator.
Refer to: Intake Air Resonator .
If a new component has been installed, configure using the approved diagnostic equipment.
General Equipment: Jaguar approved diagnostic tool