Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be prepared to collect escaping coolant.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle.
Refer to: LIFTING .
Drain the cooling system
Refer to: Cooling System Draining and Vacuum Filling .
Remove the accessory drive belt.
refer to: Accessory Drive Belt
Remove the low pressure Exhaust Gas Recirculation (EGR) valve.
Refer to: LOW PRESSURE EXHAUST GAS RECIRCULATION VALVE .
Remove the EGR pressure sensor.
Release the wiring harness
Disconnect the upper coolant pipe. Discard the O-ring seal.
Disconnect the lower coolant pipe.
Disconnect the EGR cooler intake pipe.
Remove the low pressure EGR cooler. Discard the O-ring seal and gasket.
NOTE: Do not disassemble further if the component is removed for access only.
Remove the low pressure EGR temperature sensor.