Removal And Installation: Installation
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Install the EGR valve.
Torque:
- Upper retaining bolt 12 Nm
- Lower retaining bolts 7 Nm
-
- Install the EGR valve inlet pipe.
- Install a new gasket.
Renew Part: EGR inlet pipe to EGR valve gasket.
- Torque: 12 Nm
- Connect the 2 coolant hoses.
- Connect the electrical connector.
-
NOTE: This step only applies to vehicles fitted with a high pressure Exhaust gas Recirculation (EGR) cooler.
- Install the high pressure EGR valve to high pressure EGR cooler pipe.
- Install new gaskets.
Renew Part: Exhaust gas recirculation pipe gasket.
-
NOTE: This step only applies to vehicles not fitted with a high pressure Exhaust Gas Reciculation (EGR) cooler.
- Install the high pressure EGR valve to intake manifold connecting pipe.
- Install a new gasket.
Renew Part: Exhaust gas recirculation pipe gasket.
- Install a new O-ring seal.
Renew Part: EGR pipe to intake manifold O-ring seal.
- Torque:
EGR pipe to EGR valve bolts 12 Nm
EGR pipe to intake manifold bolts 7 Nm
- Fill and bleed the cooling system.
Refer to: Cooling System Partial Draining, Filling and Bleeding .
- Install the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .