LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> High Pressure Exhaust Gas RECIRCULATION Cooler >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • To install, reverse the removal sequence.
  1. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  2. Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .
  3. Refer to: Cooling System Draining and Vacuum Filling .

  4. Refer to: Coolant Expansion Tank .

  5. Refer to: Diesel Fuel System Health and Safety Precautions .
  6. CAUTION:
    • Be prepared to collect escaping fuel.
    • Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
    G11308144
  7. CAUTION: Be prepared to collect escaping coolant.
    G11308145
  8. CAUTION: Be prepared to collect escaping coolant.
    G11308146
  9. G11308147
  10. G11308148
  11. G11308149

    Torque: 7 Nm 

  12. G11308150

    Torque: 12 Nm 

  13. G11308151

    Torque: 4 Nm 

  14. CAUTION: Install a new gasket.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11308152

    Torque:

    1. 12 Nm 
    2. 7 Nm 
  15. G11308153

    Torque: 3.6 Nm 

scientia non olet · About LEMON Manuals