LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Diesel Exhaust Fluid Injector >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  2. G11308104
  3. G11308105
  4. The quick connector is pushed in an axial direction onto the SAE spigot, until you hear a audible click.
    CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    • Make sure that all disconnected electrical connectors and sockets are sealed.
    G11308106
  5. NOTE: Discard the bolt and clamp.
    G11308107

    Renew Part: Diesel exhaust fluid injector seal Quantity: 1

    Renew Part: Diesel exhaust fluid injector clamp and bolt Quantity: 1

scientia non olet · About LEMON Manuals