Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Raise and support the vehicle.WARNING: Make sure to support the vehicle with axle stands.
- Refer to: Diesel Exhaust Fluid Tank Drain And Refill .
-
WARNING: Be prepared to collect escaping fluid.
-
CAUTION: Make sure that all disconnected electrical connectors and sockets are sealed.
-
CAUTION: Discard the bolts.
-
WARNING: Be prepared to collect escaping fluid.CAUTION: Do not use excessive force to remove the component.
- If a new pump is being installed this step is not required.CAUTION: Using a suitable tool, remove the seals.
- If a new pump is being installed this step is not required.CAUTION: Discard the components.
- If a new pump is being installed this step is not required.CAUTION:
- Using a suitable tool, remove the seals.
- Discard the components.