LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Emission Control - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine Emission Control - INGENIUM I4 2.0L Diesel >> Diesel Exhaust Fluid Injection Pump >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a new pump is being installed this step is not required.
    CAUTION:
    • Lubricate seals with deionized water.
    • Make sure that the components are clean, dry and free from corrosion and foreign material.
    NOTE: Install new seals.
    G11308162
  2. If a new pump is being installed this step is not required.
    CAUTION: Make sure that new components are installed.
    G11308161

    Renew Part: Sleeve and isolator assemblies Quantity: 1

  3. If a new pump is being installed this step is not required.
    CAUTION: Install the new sleeves and isolators to the Diesel Exhaust Fluid pump.
    G11308160
  4. CAUTION:
    • Make sure that new bolts are installed.
    • The bolts must be re-torqued after 2 minutes.
    G11308166

    Renew Part: Diesel exhaust fluid injection pump bolts Quantity: 1

    Torque: 6 Nm 

  5. G11308157
  6. CAUTION: Lubricate with deionized water.
    G11308168
  7. The quick connector is pushed in an axial direction onto the SAE spigot, until you hear a audible click.
    G11308156
  8. Refer to: Diesel Exhaust Fluid Tank Drain And Refill .
scientia non olet · About LEMON Manuals