LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Front Suspension -- XE (X760)) >> Front Suspension >> Wheel Knuckle - RWD >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Refer to: Wheel and Tire
  3. G11305444
  4. G11305535
  5. CAUTION: Discard the bolts.
    NOTE: Using a suitable tie strap, position and secure the component to one side.
    G11305458
  6. CAUTION: Discard the nut.
    G11305537
  7. NOTE: Loosen but do not fully remove.
    G11305538
  8. G11305522

    Special Tool(s):  JLR-204-793

    Torque Specification: 60 Nm 

  9. CAUTION: Discard the nut.
    G11305540
  10. CAUTION: Discard the nut and bolt.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11305541
  11. G11305542
  12. G11305543
  13. CAUTION:
    • Do not attempt to release the wheel hub by hitting it with a hammer directly, loosen the wheel hub retaining bolts partially before applying an even amount of force to the head of each bolts to release the wheel hub from the wheel knuckle. Failure to follow this instruction may cause damage to the component.
    • Discard the bolts.
G11305508
scientia non olet · About LEMON Manuals