Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure that new bolts are installed.

Install the Torx bolts and tighten in the sequence shown.

Fig 1: Front Wheel Bearing And Wheel Hub Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Wheel bearing bolts Quantity: 1.

Torque Specifications:

Stage 1: 170 Nm

Stage 2: Loosen 90°

Stage 3: 90 Nm

Stage 4: 120°
To install, reverse the removal procedure.
CAUTION: Do not use air tools to install the driveshaft nut.

Use the original nut to install the halfshaft into the hub.

Torque Specification: 150 Nm
CAUTION: Do not use air tools to remove the driveshaft nut.

Remove the original nut.
CAUTION: Do not use air tools to install the driveshaft nut.

Install a new nut.

Torque Specifications:

Stage 1: 80 Nm

Stage 2: 60°