Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Lap each valve to seat using fine grinding paste.
- Apply Prussian Blue to valve seat, insert valve and press it into position several times without rotating. Remove and check valve for even and central seating, seating position shown by blue should be in centre of valve face.
Remove all traces of grinding paste on completion.
Install spring cap, valve spring and valve.
NOTE: Lubricate valve stems and assemble valves.
Refer to: Cylinder Head .