LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Oil Pan - AWD >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect .
  2. Raise and support the vehicle.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  3. Refer to: Engine Oil Draining and Filling .
  4. Refer to: Front Subframe - INGENIUM I4 2.0L Diesel .
  5. Refer to: Halfshaft Support Bracket .
  6. Refer to: Crankshaft Pulley .
  7. G11309091

    Torque Specification: 25 Nm 

  8. G11309092

    Torque Specification: 25 Nm 

  9. CAUTION: Inspect the seal and replace if necessary.
    G11309105

    Torque Specification: 12 Nm 

  10. G11309106

    Torque Specification: 7 Nm 

  11. G11309095

    Torque Specification: 12 Nm 

  12. G11309096

    Torque Specification: 48 Nm 

  13. G11309109
  14. G11309098

    Torque Specification: 25 Nm 

  15. NOTE: Loosen, but do not fully remove the bolts.
    G11309099

    Torque Specification: 25 Nm 

  16. G11309100
  17. G11309101
scientia non olet · About LEMON Manuals