LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Oil Cooler >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect .
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: Cooling System Partial Draining, Filling And Bleeding .
  4. G11309119

    Torque Specification: 12 Nm 

  5. CAUTION: Be prepared to collect escaping coolant.
    G11309120
  6. CAUTION:
    • Be prepared to collect escaping fluids.
    • Install a new gasket.
    G11309121

    Torque Specification:

    1. Stage 1: 15 Nm 
    2. Stage 2: 25 Nm 
scientia non olet · About LEMON Manuals