Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Make sure the Fuel pump sprocket is aligned with the timing mark on the cylinder block.
Install the timing chain.
Install a new timing chain guide.
CAUTION: Make sure the highlighted links on the timing chain are in line with the timing marks as illustrated.
- Renew Part: Lower timing chain guide
- Torque Specification: 25 Nm
Install a new timing chain guide.

Renew Part: Upper timing chain guide
CAUTION: Make sure the highlighted links on the timing chain are in line with the timing marks as illustrated.

Torque Specification: 35 Nm
Install a new timing chain guide.
- Renew Part: Lower timing chain guide
- Torque Specification: 12 Nm
Install a new hydraulic timing chain tensioner.
- Renew Part: Timing chain tensioner
- Torque Specification: 12 Nm
CAUTION: Make sure the lower timing chain tensioner is fully deployed.
Install the timing chain.
CAUTION: Make sure the highlighted links on the timing chain are in line with the timing marks as illustrated.
Install a new timing chain guide.
- Renew Part: Upper timing chain guide
- Torque Specification: 25 Nm
CAUTION: Make sure the highlighted links on the timing chain are in line with the timing marks as illustrated.
- Install the camshaft sprocket
- Install a new bolt, but do not fully tighten at this stage.
  Renew Part: Camshaft sprocket bolt
Install a new timing chain guide.
- Renew Part: Lower timing chain guide
- Torque Specification: 25 Nm
Install a new hydraulic timing chain tensioner.
- Renew Part: Timing chain tensioner
- Torque Specification: 55 Nm
CAUTION: Make sure the lower timing chain tensioner is fully deployed.
- Special Tool(s): JLR-303-1631
- Torque Specification: 10 Nm
Install a new bolt.
1. Torque Specification:
  Stage 1: 10 Nm
  
  Stage 2: Loosen: 90°
  
  Stage 3: 25 Nm
  
  Stage 4: 40°
- Remove the special tool.
- Special Tool(s): JLR-303-1631
- Remove the special tool.
- Special Tool(s): JLR-303-1625
- Remove the special tool.
- Special Tool(s): JLR-303-1630
Install the lower timing cover.
Refer to: Lower Timing Cover .
Install the upper timing cover.
Refer to: Upper Timing Cover .
Install the charge air cooler.
Refer to: Charge Air Cooler .
Connect the battery ground cable.
Refer to: Battery Disconnect and Connect .