LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Left Engine Mount >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount in the correct position.
    NOTE: Make sure that the component is installed to the noted position in the removal steps.
  2. Install the engine mount bracket and tighten the 4 bolts to the correct torque.

    Torque Specification: 60 Nm 

  3. Install the 2 engine mount retaining bolts and tighten to the correct torque.

    Torque Specification: 47 Nm 

    • Install the engine mount nut.

      Torque Specification: 60 Nm 

    • Install the ground cable.

      Torque Specification: 20 Nm 

  5. Remove the hydraulic jack from under the vehicle.

    General Equipment: Hydraulic floor jacks (2 tonnes minimum capacity)

  6. Install the vacuum pipe onto the engine mount assembly.
  7. Install the air deflector.

    Refer to: Air Deflector .

scientia non olet · About LEMON Manuals