LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Intake Manifold >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

    General Equipment:  Two-post lift

  2. Always follow the Diesel fuel system health and safety precautions, when carrying out any repairs to the fuel system. Refer to: Diesel Fuel System Health and Safety Precautions .
  3. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  4. Remove the engine cover.

    Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .

  5. Remove the left side secondary bulkhead panel.

    Refer to: Secondary Bulkhead Left Panel - INGENIUM I4 2.0L Diesel .

  6. Remove the Exhaust Gas Recirculation valve.

    Refer to: High Pressure Exhaust Gas Recirculation Valve .

  7. Remove the high pressure fuel rail shield.
    NOTE: If equipped.
    G11308973
  8. Remove the fuel supply pipe brackets.
    G11308974
  9. Disconnect the Emergency Park Release (EPR) cable.
    G11308975
  10. Release the coolant hose.
    G11308976
  11. Disconnect and release the glow plug wiring harness.
    G11308977
  12. Release the intake manifold air intake hose.
    G11308978
  13. Remove the rear intake manifold support bracket.
    G11308979
  14. Remove the front intake manifold support bracket.
    G11308980
  15. Remove the intake manifold and discard the gasket.
    CAUTION: Bolts must be released in the sequence illustrated.
    G11308981
  16. Remove the throttle body assembly. Discard the seal.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11308982
  17. Remove the wiring harness brackets.
    G11308983
  18. Remove the Manifold Absolute Pressure (MAP) sensor.
    G11308984
scientia non olet · About LEMON Manuals