Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Under no circumstances should the flywheel retaining bolts be inserted into the crankshaft with the flywheel removed. Failure to follow this instruction will result in damage to the engine.

NOTE: Do not insert the bottoming tap more than the depth of the threaded holes (16mm). Apply tape to the bottoming tap 16mm from the end as a visual guide.
- Using a suitable bottoming tap, clean out the threads.
- Using suitable brake cleaner, remove any foreign material from the threads.
WARNING: This step requires the aid of another technician.
CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Make sure that new bolts are installed.
- Tighten the bolts in the sequence shown.
Renew Part: Flywheel bolts
1. Torque Specification:
  Stage 1 30 Nm
  
  Stage 2 120°
To install, reverse the removal procedure.