LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> FLEXPLATE >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Under no circumstances should the flexplate retaining bolts be inserted into the crankshaft with the flexplate removed. Failure to follow this instruction will result in damage to the engine.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some illustrations may show the engine removed for clarity.
  1. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  2. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  3. Remove the charge air cooler.

    Refer to: Charge Air Cooler .

  4. Refer to: Transmission RWD - INGENIUM I4 2.0L Diesel .

    Refer to: Transmission AWD - INGENIUM I4 2.0L Diesel .

  5. G11308988
    • Disconnect the electrical connector.
    • Release the wiring harness clips.
  6. G11308989
    • Release the wiring harness clip.
    • Remove the charge air cooler mounting bracket nuts.
  7. Remove the charge air cooler mounting bracket.
    G11308990
  8. Install the special tool onto the crankshaft pulley.
    CAUTION:
    • Only rotate the crankshaft clockwise.
    • The four locating pegs of the special tool must be installed correctly into the crankshaft pulley.
    G11309142

    Special Tool(s):  JLR-303-1630

  9. Remove the flexplate.
    CAUTION: Remove and discard the flexplate bolts.
    G11309143
scientia non olet · About LEMON Manuals