Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe due care when working near a hot exhaust system.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

All vehicles

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
Disconnect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .
Remove the turbocharger.
Refer to: Turbocharger .

Vehicles with diesel particulate filter (DPF)
Remove the catalytic converter and Diesel Particulate Filter (DPF) assembly.
Refer to: Catalytic Converter and Diesel Particulate Filter Assembly .

Vehicles without diesel particulate filter (DPF)
Remove the catalytic converter assembly.
Refer to: Catalytic Converter .

All vehicles
Remove the heatshields.
- Release the Exhaust Gas Recirculation (EGR) pipe.
- Remove and discard the gasket.
- Remove the exhaust manifold.
- Remove and discard the gasket.