General Procedures: Check

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure that all openings are sealed.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .
- Loosen the element cover four complete turns to allow engine oil to drain from the filter cover.
- Allow the engine oil to drain from the oil filter element housing for two minutes.
Remove the engine oil filler cap.
Remove the engine oil level indicator.
- Install the special tool.
  Special Tool(s): 303-1484
- Using the special tool, drain the engine oil.
Remove the special tool.

Special Tool(s): 303-1484
Install the engine oil filler cap.
Remove the oil filter element housing.
WARNING: Be prepared to collect escaping oil.
- Remove and discard oil filter element from oil filter housing.
- Remove and discard the seals.
10
- Install a new oil filter.
  Renew Part: Oil filter.
- Install a new O-ring seals.
  Renew Part: Oil filter O-ring seal.
- Lubricate the oil filter O-ring seal with clean engine oil.
Torque Specification: 25 Nm
Remove the engine oil filler cap.
Fill the engine with the recommended oil to the correct level.
Refer to: Specifications .
Install the engine oil filler cap.
Check the engine oil level.
NOTE: Make sure that the component is correctly installed.
- Start the engine and allow to idle for 2 minutes.
- Check for leaks.
- Stop the engine.
- Check the engine oil level.
  CAUTION: Allow for the engine oil level to stabilize. This may take up to 20 minutes.
- Top up as required.
Install the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .