Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Apply silicone gasket sealant or equivalent meeting Jaguar specification.
CAUTION: Make sure that the surface is clean and free of foreign material.

Refer to: Specifications .
Install the engine front cover.
NOTE: Do not fully tighten the bolts at this stage.
CAUTION: Make sure that the component is correctly located on the dowel.
- Install the crankshaft pulley.
- Install the special tool as illustrated.
  Special Tool(s): JLR-303-1628
- Install the crankshaft pulley bolts.
  1. Torque Specification:
    Stage 1: 37 Nm
    
    Stage 2: 90°
  2. Remove the special tool.
    Special Tool(s): JLR-303-1628
Secure the engine front cover.
Torque Specification: 12 Nm
Install the accessory drive belt idler pulley.

Torque Specification: 48 Nm
Install the accessory drive belt idler pulley.

Torque Specification: 25 Nm
Install the charge air cooler mounting bracket.
Torque Specification: 47 Nm
Install the charge air cooler mounting bracket nuts.
- Torque Specification: 12 Nm
- Secure the wiring harness clip.
- Connect the electrical connector.
- Secure the wiring harness clips.
Install the charge air cooler.
Refer to: Charge Air Cooler .
Install the accessory drive belt.
Refer to: Accessory Drive Belt .