LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Cylinder Head >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Remove the oil filter element.

    Refer to: Oil Filter Element .

  3. Remove the intake manifold.

    Refer to: Intake Manifold .

  4. Remove the exhaust manifold.

    Refer to: Exhaust Manifold .

  5. Remove the valve cover.

    Refer to: Camshaft Carrier .

  6. Remove the coolant outlet hose.
    CAUTION: Be prepared to collect escaping coolant.
    G11309071
  7. Release the coolant bypass hose.
    G11309072
  8. Remove the 4 glowplugs
    G11309073
  9. Remove the 2 oil filter element housing bolts.
    G11309074
  10. Remove the remaining bolt and then remove the oil filter element housing.
    CAUTION: Care must be taken not to damage the component.
    G11309075
  11. Remove and discard the O-ring seals from the oil filter element housing.
    G11309076
  12. Remove and discard the cylinder head temperature sensor.
    G11309077
  13. Remove the 16 camshaft rocker arms and the 16 hydraulic adjusters.
    CAUTION:
    • Make sure that the components are clean, dry and free from corrosion and foreign material.
    • Check all timing components for wear and install new components if required.
    NOTE:
    • Note the orientation of the components prior to removal
    G11309078
  14. Remove the 4 cylinder head bolts.
    G11309079
  15. Remove and discard the cylinder head bolts in the sequence illustrated.
    G11309080
  16. Remove the cylinder head assembly.
    CAUTION:
    • Take extra care not to damage the edges of the component.
    • Take extra care not to damage the surrounding components.
    G11309081
  17. Remove and discard the cylinder head gasket.
    G11309082
  18. Remove the cylinder head dowels
    CAUTION: Make sure that the dowels and dowel holes are clean and free from debris and foreign material.
    G11309083
  19. Clean and inspect the cylinder head and cylinder block.
    CAUTION: Only use a plastic scraper to clean off the old gasket.
    G11309084
scientia non olet · About LEMON Manuals