Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Check cylinder head face for distortion, across the center and from corner to corner.

Refer to: Cylinder Head Distortion .
Refer to: Cylinder Head Gasket Selection - INGENIUM I4 2.0L Diesel .
CAUTION: Make sure that the dowels and dowel holes are clean and free from debris and foreign material.
NOTE: The cylinder head gasket must be installed over the cylinder head to cylinder block dowels.

Renew Part: Cylinder head gasket
CAUTION: Make sure that the component is correctly located on the locating dowels.

NOTE: With assistance, install the component.
CAUTION:
- Make sure that new cylinder head bolts are installed.
- Tighten the bolts in the indicated sequence.
Renew Part: Cylinder head bolts
1. Torque Specification:
  Stage 1: 10 Nm
  
  Stage 2: 20 Nm
  
  Stage 3: 53 Nm
CAUTION: Carry out the following procedure in the indicated sequence.
1. Torque Specification:
  Stage 1:
  
  Loosen the bolt 180°
  
  Stage 2:
  
  Tighten the bolt 53 Nm
CAUTION: Tighten the bolts in the indicated sequence.
1. Torque Specification:
  Stage 1: 90°
  
  Stage 2: 120°
Torque Specification: 13 Nm
NOTE: Install the camshaft followers in the sequence mark in the removal step.
CAUTION: Make sure that a new component is installed.

Renew Part: Cylinder head temperature sensor

Torque Specification: 11 Nm
CAUTION: If accidentally dropped or knocked install a new glow plug.

Torque Specification: 13 Nm
Torque Specification: 25 Nm
CAUTION: Install new o-ring seals

Renew Part: Oil filter housing inlet / outlet O-ring seals
Torque Specification: 12 Nm
Torque Specification: 12 Nm
Install the valve cover.
Refer to: Camshaft Carrier .
Install the exhaust manifold.
Refer to: Exhaust Manifold .
Install the intake manifold.
Refer to: Intake Manifold .
Install the oil filter element.
Refer to: Oil Filter Element .
Lower the vehicle.