LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Engine - INGENIUM I4 2.0L Diesel >> Crankshaft Pulley >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  2. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Refer to: Accessory Drive Belt .
  4. Refer to: Charge Air Radiator .
  5. G11308988
  6. G11308989

    Torque Specification: 12 Nm 

  7. G11308990

    Torque Specification: 90 Nm 

  8. Install special tool JLR-303-1630 to crankshaft damper. Make sure central hub is located correctly.
    NOTE: Only rotate the crankshaft clockwise.
    G11308991

    Special Tool(s):  JLR-303-1630

  9. Remove four crankshaft damper bolts.
    G11308992

    Special Tool(s):  JLR-303-1630

  10. Remove crankshaft damper.
    G11308993

    Special Tool(s):  JLR-303-1630

  11. Using the special tool remove and discard the front crankshaft seal.
    G11308994

    Special Tool(s):  JLR-303-1628

scientia non olet · About LEMON Manuals