Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that these components are installed to the noted removal position.
- Install the camshafts.
- Install the camshaft bearing caps. Tighten the bolts finger tight before final tightening in sequence illustrated.
  Torque Specification: 11 Nm
Using the special tool align the camshafts.

Special Tool(s): JLR-303-1625
Install the valve cover. Make sure a new gasket is installed.
CAUTION: Install and finger tighten bolts before final tightening in sequence illustrated.

Renew Part: Camshaft cover gasket.

Torque Specification:
- M8 x 80
  Stage 1: 15 Nm
  
  Stage 2: 45°
- M8 x 40 25 Nm
Install the crankcase breather.
Install the cylinder head temperature sensor electrical connector bracket.
Torque Specification: 12 Nm
Install the wiring harness and connect the 2 electrical connectors.
Install the Noise, Vibration and Harshness (NVH) material.
Install the camshaft gear and bolt finger tight.

Renew Part: Variable camshaft timing actuator bolts.
Install the special tool.

Special Tool(s): JLR-303-1631
Fully tighten the camshaft gear bolt and remove the special tool.

Special Tool(s): JLR-303-1631

Torque Specification:
1. Stage 1: 80 Nm
2. Stage 2: 90°
Install the upper timing chain.
Refer to: Upper Timing Chain .
Install the fuel injectors.
Refer to: Fuel Injectors .
Install the fuel rail.
Refer to: Fuel Rail .