LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Information & Entertainment System -- XE (X760)) >> Information And Entertainment System >> Diagnosis And Testing >> SD Card Installation Checks

SD Card Installation Checks

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

In order for the navigation data to be read successfully from a valid SD card, the SD card must be unlocked and inserted into the SD reader with the correct orientation. With the SD card label-side up and the diagonal corner of the SD card situated top-right, the locking tab may be seen on the left-side of the SD card. Check that the tab is in the unlocked position (ie: with the locking tab positioned towards the top of the SD card). The unlocked SD card should be inserted into the SD reader slot with the label-side facing downwards and the contactor surfaces forward. Once satisfied that the SD card is unlocked and correctly installed into the SD card reader, EITHER:

  1. Turn off ignition and lock the vehicle using the remote fob. Wait for four minutes before unlocking the vehicle and starting the engine. Then re-enter the navigation system via the infotainment home screen and continue with the activation process as described above, OR:
    1. If the SD card is reinserted before the vehicle has been shut down and a Retry  message has appeared on the infotainment screen, the system will automatically reset and initialize. Once the infotainment home screen appears, select Navigation and continue with the activation process as described above
scientia non olet · About LEMON Manuals