Pinpoint Test A: DTC Check
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- A1: CHECK FOR WIPER RELATED DTCS
- Using the manufacturer approved diagnostic system, check if the body control module has logged DTC B1C45-67 (Front Wiper Park Position Switch Stuck - Signal incorrect after event)
Is DTC B1C45-67 logged in the body control module?
- Yes : If DTC B1C45-67 is logged, this may indicate a wiper motor fault. Continue diagnostic procedures GO to Pinpoint Test B .
- No : Consult the symptom chart below and perform any appropriate corrective actions. If the fault persists, contact the JLR Service Helpdesk