Secondary Bulkhead Right Panel - TDV6 3.0L Diesel (G1879662): Installation

• Install the secondary bulkhead right panel.
• Install and tighten the 5 bolts.

Torque  : 5.4 Nm 

• Install the coolant pipe assembly.
• Connect and secure the 4 coolant hoses.
• Install and tighten 2 bolts.

Torque  : 10 Nm 

• Install the wiring harness bracket.
• Install and tighten the 4 bolts.

  Torque  : 10 Nm 

• Install the wiring harness clip to the bracket.
• Install the pipe clip onto the pipe.

• Install the fuel filter.
• Install the clip.
• Connect the ground cable connector.

• Install the brake vacuum pipe to the bulkhead panel.
• Connect the brake vacuum pipe connector.

• Install the engine wiring harness to the bulkhead panel.
• Connect the 2 electrical connectors.

Torque  : 3.6 Nm 

• Install the rear engine cover.
• Install and tighten the 4 bolts.

  Torque  : 10 Nm 

• Install the 3 wiring harness clips.

• Install the engine wiring harness cover.

• Install the engine compartment brace.
• Install and tighten the 4 bolts.

Torque  : 55 Nm 

Refer to: COWL PANEL 

Refer to: ENGINE COVER - TDV6 3.0L DIESEL

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING (G1822256)