Wheel Knuckle (G1899823): Installation

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 9 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 9 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 35 Nm
WARNING: The component(s) may be heavy. Take extra care when handling.
CAUTION:
- Take extra care when handling the assembly. Failure to follow this instruction might result in damage to the CV or the CV boot.
- Make sure that a new bolt is installed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Wheel knuckle nut and bolt Quantity: 1 .

Torque

Stage 1: 110 Nm

Stage 2: 60°
CAUTION:
- Take extra care when installing the upper control arm. Failure to follow this instruction might result in damage to the CV or the CV boot.
- Make sure that a new nut and bolt is installed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Rear upper arm to wheel knuckle nut and bolt Quantity: 1 .

Torque

Stage 1: 60 Nm

Stage 2: 60°
CAUTION:
- Take extra care when installing the halfshaft. Failure to follow this instruction might result in damage to the CV or the CV boot.
- Do not use air or power tools to remove or install the halfshaft nut.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a new halfshaft nut to aid installation of the halfshaft into the hub.

Renew Part: Rear halfshaft nut Quantity: 1 .
CAUTION: Make sure that new nuts and bolts are installed

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Toe link to knuckle bolt(s) Quantity: 1 .

Torque

Stage 1: 48 Nm

Stage 2: 60°
CAUTION:
- Discard the nuts and bolt.
- Make sure that a new nut and bolt is installed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Rear lower control arm ball join nut Quantity: 1 .

Torque

Stage 1: 60 Nm

Stage 2: 60°
WARNING: Using a suitable stand, support the lower arm.

CAUTION: Make sure that a new nut and bolt is installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Shock absorber to wheel knuckle mounting nut and bolt Quantity: 1 .

Torque

Stage 1: 70 Nm

Stage 2: 120°
CAUTION: Make sure that new bolts are installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Brake caliper housing bolt(s) Quantity: 1 .

Torque: 110 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 9 Nm
CAUTION: Do not use air or power tools to remove or install the halfshaft nut.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Apply the foot brake and tighten the new halfshaft nut.
  Torque: 175 Nm
- Loosen the halfshaft nut.
  Loosen: 90°
- Install and tighten a halfshaft nut.
  Torque
  
  Stage 1: 90 Nm
  
  Stage 2: 60°
Refer to: WHEEL AND TIRE - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L RETROL (G1967109)