Brake Caliper - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L RETROL (G1822055): Removal
WARNING:
If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
CAUTION:
Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
NOTE:
Removal steps in this procedure may contain installation details.
- Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
-
NOTE: This step is only required if the diagnostic tool is not available.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
-
NOTE: This step is only required if the vehicle has no battery power.
Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL ROWER (G1822068)
-
WARNING: Make sure to support the vehicle with axle stands.
- Raise and support the vehicle.
-
CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
-
CAUTION:
- Inspect the brake hose sealing washers for signs of damage, if damage is present discard the sealing washers.
- Be prepared to collect escaping fluids.
NOTE: Make sure that all openings are sealed.Torque: 32 Nm
- CAUTION: Be prepared to collect escaping fluids.NOTE: Make sure that all openings are sealed.
Remove the flexible brake hose.
Renew Part: Brake hose Quantity: 1 .
Torque: 15 Nm
Torque: 28 Nm
- CAUTION: Remove and discard the O-ring seal.NOTE: Do not disassemble further if the component is removed for access only.
Renew Part: Electric park brake actuator O-ring seal Quantity: 1 .
Torque: 8 Nm