Brake Pads - INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L Petrol (G1898590): Removal
WARNING:
- Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
- If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM .
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Remove the front wheels and tires.
Refer to: REAR SUSPENSION - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL .
-
NOTE: If equipped.
-
NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
-
CAUTION: Do not allow the brake caliper to hang on the brake hose.
Tie aside.