LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> E-Pace Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster -- E-Pace/X540 >> Instrument Cluster (G1791761) >> Removal And Installation >> Instrument Cluster (G2165957) >> Installation

Instrument Cluster (G2165957): Installation

    • Connect the electrical connector.
    • Install the instrument cluster assembly.
    • Install the instrument cluster upper cover.
    • Install and tighten the 2 screws.

    Torque  : 4 Nm 

    • Install the 2 spacers.
    • Install and tighten the 3 screws.

      Torque  : 4 Nm 

    • Install the screw cover.
    • Connect the 2 electrical connectors.
    • Install the instrument cluster surrounding trim.
  5. Reposition the steering column.
  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  7. CAUTION: Only applicable vehicles with software numbers K8D2-14C104-AC or L8B2-14C104-AC as detailed in removal step 2.
    NOTE:
    • Only complete this step if a new instrument cluster is to be installed.
    • This step is only applicable to 19MY onward vehicles.
    • Non-NAS Markets only.
    • SRO must be claimed separately.

    Install a new RFA  .

    Refer to: REMOTE FUNCTION ACTUATOR .

  8. NOTE: Only complete this step if a new instrument cluster was installed.

    Use the Jaguar approved diagnostic equipment to configure the instrument cluster.

    General Equipment: Jaguar diagnostic equipment 

scientia non olet · About LEMON Manuals