Tire Low Pressure Sensor (G1062014): Installation

CAUTION:
- Make sure that the seal is correctly located.
- Make sure that new components are installed.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the washer and seal, making sure the valve remains pressed fully onto its seat.

Renew Part: Tire pressure monitoring system sensor seal kit Quantity: 1 .
WARNING:
- Make sure that any corrosion or dirt is removed from the mating surfaces.
- Make sure that a new tire valve, valve core, seal, washer, cap and retaining nut is installed.
CAUTION:
- Use lint free cloth.
- Only use moderate force when installing the sensor.
NOTE: Only tighten the nut finger tight at this stage.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the tire low pressure sensor and support the sensor body in position.
- Support the back of the valve stem in order to prevent rotation to the tire low pressure sensor body.
- Gently push the nut towards the center of the wheel. Tighten the nut.
  Torque: 8 Nm
Install the tire and balance the wheel.
Refer to: WHEEL AND TIRE
WARNING: Make sure to support the vehicle with axle stands.

Lower the vehicle.