LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XJR575 >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- XJ/X351 >> Vehicle Dynamic Suspensions >> Removal And Installation >> Integrated Suspension Control Module >> Removal

Integrated Suspension Control Module : Removal

CAUTION: Calibration of the suspension system must be carried out after the following components have been replaced: suspension control module, suspension height sensor, suspension components and body panels incorporating suspension fixing points.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
  2. Refer to: RIGHT LOADSPACE TRIM PANEL
  3. G11284015Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 7 Nm 

  4. G11284016Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 7 Nm 

scientia non olet · About LEMON Manuals