Rear Coolant Manifold (G2368812): Installation

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 6 bolts.
Torque : 9 Nm
Install the wiring harness clip to the left side of the rear coolant manifold.
- Connect the electrical connector.
- Install the 2 wiring harness clips to the right side of the rear coolant manifold.
- Connect the rear coolant manifold left hose.
- Install the coolant hose clip.
- Install the coolant hose bracket.
- Install and tighten the bolt.
  Torque : 12 Nm
- Install the wiring harness clip.
- Install the rear coolant manifold right hose.
- Connect the 2 coolant hose connectors.
Install and tighten the bolt to the coolant hose bracket.
Torque : 12 Nm
- Reposition the wiring harness into the correct location.
- Install and tighten the 2 bolts.
Torque : 9 Nm
Install the vacuum pipe to the clip.
Install the secondary bulkhead right panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL
Install the secondary bulkhead left panel.
Refer to: SECONDARY BULKHEAD LEFT PANEL
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1816935)