Throttle Body (G1557479): Removal

WARNING: This page is about a different car, the 2019 Jaguar XJ and 2018 Jaguar XJ. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR - V8 S/C 5.0L PETROL (G1271939)
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1816935)
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE:
- This step should only be carried out on vehicles pre 2015.
- Remove and discard the seals.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Engine coolant outlet seal Quantity: 1 .

Torque : 10 Nm
NOTE:
- This step should only be carried out on vehicles from 2015 onwards.
- Remove and discard the seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Engine coolant outlet seal Quantity: 1 .

Torque : 10 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 10 Nm
CAUTION:
- Take extra care when removing the throttle body, failure to follow this instruction may result in damage to the manifold absolute pressure and temperature (MAPT) sensor.
- Do not attempt to clean the throttle body bore, build up of deposits reduces air leakage past the throttle plate at the fully closed position.
NOTE:
- Remove and discard the gasket.
- Install a new gasket.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Throttle body gasket Quantity: 1 .